Description
Fluke i30 AC/DC Current Clamp (30A)
The Fluke i30 AC/DC Current Clamp (30A) is used to measure AC and DC current and attached to other devices such as multimeters to enable current measurements to be taken.
Featuring 19mm diameter jaws, this clamp is best suited to clamping onto smaller cables/conductors and can measure from 30mA to 30A DC and 30mA to 20A AC rms.
This device uses hall effect technology to carry out measurements and provides accurate measurements of current without the need to break a circuit or use a full clamp meter.
Fluke i30 Technical Specifications
| Specified current range | | 30 mA to 30A dc, 30 mA to 20 A ac rms |
|
| Usable current range | | 5 mA to 30 A dc, 30 mA to 20 A ac rms |
|
| Crest Factor | |
| Output sensitivity | |
| Accuracy (at 25 °C) | |
| Resolution | |
| Load impedance | |
| Conductor position sensitivity | | ± 1 % relative to center reading |
|
| Frequency range | |
| Temperature coefficient | |
| Power supply | | 9 V Alkaline, MN1604/PP3, 30 hours, low battery indicator |
|
| Working voltage (see Safety Standards section) | |
| General Specifications |
| Maximum conductor size | |
| Output connection | |
| Output zero | | Manual adjust via thumbwheel |
|
| Cable length | |
| Operating temperature range | |
| Storage temperature range (with battery removed) | |
| Operating humidity | | 15 % to 85 % (non-condensing) |
|
| Weight | |
| Safety standards | | BS EN 61010-1:2001 | | BS EN 61010-2-032:2002 | | BS EN 61010-031:2002 | | 300 Vrms, Category III, Pollution Degree 2 | | Use of the probe on uninsulated conductors is limited to 300 V ac rms or dc and frequencies below 1 kHz. |
|
| EMC Standards | | EN 61326: 1998 A1, A2, & A3 |
|
